O w n e r O s M a n u a lSetting the Date and Time
You can reset the clock in the CPU so it
corresponds to your specific time zone.
Note: There is no console equivalent for
this function.
TO SET THE DATE AND TIME
From the screen:
1. Click on the Setup button in the lower
menu bar. The Setup dialog box opens.
2. Click on the General icon on the left
side of the box if itOs not already
selected.
3. The Date and Time settings appear in
the middle of the General window.
Click on the arrows next to each
setting to change it.
4. Click on the Close button in the upper
right corner of the dialog box to close
the Setup dialog box (or click on the
Setup button in the menu bar).
Setting Channel Phase
You can switch the phase of the input signal on anythe 1/4" TRS jack. However, the actual
of the first 48 channels. This is equivalent to swappingphase reversal occurs in the digital domain,
pins 2 and 3 on the XLR connector, or tip and ring onafter the mic pre and (for channels 1�12)
after the Insert jack.
Note: There is no console equivalent for
this function.
TO SET CHANNEL PHASE
From the screen:
1. Click on the PHASE button at the top of
the channel strip. When the PHASE but-
ton is lit, the signal is inverted (1801).
When the PHASE button is unlit (off),
the signal is non-inverted (01).
3-15
Start-Up |